Vent venligst...
Varen er tilføjet indkøbskurven. Se indkøbskurv her
Tom Indkøbskurv

HYNIX RAM 4 GB DDR2 667 ECC Fully Buffer

Forsiden HYNIX RAM 4 GB DDR2 667 ECC Fully Buffer
Produktet kan p.t. ikke leveres, og er muligvis udgået. Kontakt os venligst for hjælp til at finde et tilsvarende produkt.
HYNIX RAM 4 GB DDR2 667 ECC Fully Buffer (HYMP151F72CP4N3-Y5)

HYNIX RAM 4 GB DDR2 667 ECC Fully Buffer

Varenr.:
HYMP151F72CP4N3-Y5
EAN:
4047762234676
  • ECC Ja
  • Registered Ja
  • Form factor DIMM
  • Hukommelsesstørrelse 4GB
  • Type DDR2
  • Sæt Nej
  • Hastighed MHz 667MHz
Beskrivelse

Fully Buffered DIMM 4GB

HYMP151F72CP4

This Hynix’s Fully Buffered DIMM is a high-bandwidth & large capacity channel solution that has a narrow host interface.
Hynix’s FB-DIMM features novel architecture including the Advanced Memory Buffer thatisolates the DDR2 SDRAMs from the channel.
This single component located in the front side center of each DIMM, acts as a repeater and buffer for all signals and commands which are exchanged between the host controller and the DDR2 SDRAMs including data in and output.
The AMB communicates with the host controller and adjacent DIMMs on a system board using an industry standard Differential Point to Point Link Interface at 1.5V power.
The AMB also allows buffering of memory traffic to support large memory capacities.
All memory controlfor the DDR2 SDRAM devices resides in the host, including memory request initiation, timing, refresh, scrubbing, sparing, configuration access and power management.
The AMB interface is responsible forhandling channel and memory requests to and from the local FBDIMM and for forwarding request to other FBDIMMs on the memory channel.

Features
240 pin Fully Buffered ECC Dual-In-Line DDR2 SDRAM Module
JEDEC standard Double Data Rate2 Synchronous DRAMs (DDR2 SDRAMs) with 1.8V +/- 0.1V Power Supply
All inputs and outputs are compatible with SSTL_1.8 interface
Built with 1Gb DDR2 SDRAMs in 60ball FBGA
Host interface and AMB component industry standard compliant
MBIST, IBIST test functions
8 Bank architecture
OCD (Off-Chip Driver Impedance Adjustment)
ODT (On-Die Termination)
Fully differential clock operations (CK & /CK)
Programmable Burst Length 4 / 8 with both sequential and interleave mode
Auto refresh and self refresh supported
8192 refresh cycles / 64ms
Serial presence detect with EEPROM
133.35 x 30.35 mm form factor
Full DIMM Heat Spreader
This product is in compliance with the directive pertaining of RoHS.

Selvom vi gør vort bedste for at give fyldestgørende information, så er billederne kun vejledende, og selve varen er ikke nødvendigvis 100% identisk med det viste billede. Produkter kan være vist med ekstraudstyr der ikke er inkluderet eller i andre form- og farvevarianter. Hvis der er forskel mellem produktoverskrift, beskrivelse og billede, så er det produktoverskriften som gælder. Hvis du er i tvivl, så kontakt os gerne. Vi tager forbehold for trykfejl, ændring af priser og specifikationer uden varsel.